Dell Latitude 5501 Service Manual

Installing the LED board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the LED board and provides a visual representation of the installation procedure.

Installing the LED board

Steps

  1. Locate the LED board slot on your computer.
  2. Align and place the LED board on the slot on your computer.
  3. Install the single (M2x3) screw that secures the LED board to the computer.
  4. Adhere the LED board cable to the adhesive strip on the computer.
  5. Connect the LED board cable to the connector on the system board.

Next steps

  1. Install the inner frame.
  2. Install the WWAN card.
  3. Install the WLAN card.
  4. Install the HDD.
  5. Install the solid state drive.
  6. Install the battery.
  7. Install the base cover.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\