Dell Latitude 5501 Service Manual

Installing the palm-rest and keyboard assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Installing the palm-rest and keyboard assembly

Steps

Place the palm-rest and keyboard assembly on a flat surface.

Next steps

  1. Install the system board.
  2. Install the touchpad.
  3. Install the DC-in port.
  4. Install the power button with fingerprint reader.
  5. Install the display assembly.
  6. Install the speakers.
  7. Install the LED board.
  8. Install the memory module.
  9. Install the inner frame.
  10. Install the WWAN card.
  11. Install the WLAN card.
  12. Install the HDD.
  13. Install the solid state drive.
  14. Install the battery.
  15. Install the base cover.
  16. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\