Dell Latitude 5501 Service Manual

Installing the smart card reader board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the smart card reader board and provides a visual representation of the installation procedure.

Installing the smart card reader board

Steps

  1. Locate the smart card reader board slot on your computer.
  2. Align and place the smart card reader board into the slot on your computer.
  3. Install the four (M2X3) screws that secure the smart card reader board to the computer.
  4. Connect the smart card reader cable on to the connector on the system board and lock the latch.

Next steps

  1. Install the inner frame.
  2. Install the WWAN card.
  3. Install the WLAN card.
  4. Install the HDD.
  5. Install the solid state drive.
  6. Install the battery.
  7. Install the base cover.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\