Dell Latitude 5501 Service Manual

Removing the LED board

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the solid state drive.
  5. Remove the HDD.
  6. Remove the WLAN card.
  7. Remove the WWAN card.
  8. Remove the inner frame.

About this task

The figure indicates the location of the LED board and provides a visual representation of the removal procedure.

Removing the LED board

Steps

  1. Locate the LED board on your computer.
  2. Open the latch and disconnect the LED board cable from the system board.
  3. Peel back the LED board cable.
    NOTE: The LED board cable is secured to the computer by an adhesive strip.
  4. Remove the single (M2x3) screw that secures the LED board to the computer.
  5. Lift the LED board out of the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\