Dell Latitude 5501 Service Manual

Removing the smart card reader board

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the solid state drive.
  5. Remove the HDD.
  6. Remove the WLAN card.
  7. Remove the WWAN card.
  8. Remove the inner frame.

About this task

The figure indicates the location of the smart card reader board and provides a visual representation of the removal procedure.

Removing the smart card reader board

Steps

  1. Locate the Smart card reader board on your computer.
  2. Open the latch and disconnect the Smart card reader board cable from the system board.
  3. Remove the four (M2X3) screws that secure the smart card reader board to the computer.
  4. Lift the smart card reader module out of the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\