Latitude 5540 Owner's Manual

PDF

Installing the camera module

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the camera module and provide a visual representation of the installation procedure.
Figure 1. Installing the camera module
Image: Installing the camera module

Steps

  1. Align and place the camera module into the slot on the display back cover.
  2. Connect the camera module cable to the connector on the camera module.
  3. Adhere the tape to secure the camera cable to the camera.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the WLAN card.
  5. Install the 4G WWAN card or 5G WWAN card, as applicable.
  6. Install the base cover.
  7. Install the SIM card.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\