Latitude 5540 Owner's Manual

PDF

Installing the display cable

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the display cable and provide a visual representation of the installation procedure.
Figure 1. Image: Display cable
Image: Installing the display cable

Steps

  1. Connect the display cable to the connector on the camera.
  2. Adhere the display cable to the display back cover.
  3. Adhere the tape that secures the display cable to the display back cover.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the display assembly.
  4. Install the WLAN card.
  5. Install the 4G WWAN card or 5G WWAN card, as applicable.
  6. Install the base cover.
  7. Install the SIM card.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\