Latitude 5540 Owner's Manual

PDF

Installing the dummy SIM-card slot filler

Prerequisites

If you are replacing a component, remove the necessary component before the installation procedure.

About this task

The following image indicates the location of the dummy SIM-card slot filler and provides a visual representation of the dummy SIM-card slot filler installation procedure.

Installing the dummy SIM card slot filler

Steps

  1. Place the dummy SIM-card slot filler into its compartment on the palm rest.
    NOTE:Ensure that the dummy SIM-card slot filler is aligned with the ribs on the palm-rest assembly.
  2. Press the dummy SIM-card slot filler until it clicks into place and ensure it fits securely into the SIM card slot.

Next steps

  1. Install the fingerprint reader, if applicable.
  2. Install the smart card reader.
  3. Install the display assembly.
  4. Install the system board.
  5. Install the assembly inner frame.
  6. Install the battery.
  7. Install the heat sink.
  8. Install the M.2 2230 solid-state drive in Slot 2, if applicable.
  9. Install the M.2 2230 or M.2 2280 solid-state drive in Slot 1, as applicable.
  10. Install the memory modules.
  11. Install the WLAN card.
  12. Install the 4G WWAN card or 5G WWAN card, as applicable.
  13. Install the base cover.
  14. Install the SIM card.
  15. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\