Dell Latitude E6540 Owner's Manual

PDF

Installing the Network Connector

Steps

  1. Align the network connector to its position on the computer.
  2. Place the network-connector bracket on the network connector.
  3. Tighten the screw to secure the network-connector bracket to the computer.
  4. Route the cable through the routing channel.
  5. Connect the cable to the system board.
  6. Install:
    1. base-corner cover (left)
    2. base cover
    3. battery
  7. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\