Dell Latitude E6540 Owner's Manual

PDF

Installing the Power Connector

Steps

  1. Align the power connector to its position in the computer.
  2. Place the power-connector bracket on the power connector.
  3. Tighten the screw to secure the power-connector bracket to the computer.
  4. Route the cable through the routing channel.
  5. Connect the cable to the system board.
  6. Install:
    1. base cover
    2. base-corner cover (right)
    3. battery
  7. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\