Dell Latitude E7270 Owner's Manual

PDF

Installing the eDP cable

  1. Route the display cable through the routing clips on the display assembly.
  2. Affix the camera cable adhesive and connect the camera cable.
  3. Connect the eDP cable to the connector on the display assembly.
  4. Install the:
    1. display panel

    2. display bezel

      • NOTE: This is applicable only for non touch systems.
    3. display assembly

    4. battery

    5. base cover

  5. Follow the procedure in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\