- Notes, cautions, and warnings
- Preface
- Introduction
- Licensing the NetWorker Server
- Additional Information About NetWorker Licensing
- About the traditional enabler-based licensing model
- The evaluation process
- License process flow
- Permanently license the NetWorker software
- Install the NetWorker software for evaluation, if required
- Send the purchase order
- Review the License Authorization Code letter
- Obtain the host ID of the NetWorker server
- Activate the software license certificate
- Download the NetWorker license key
- Delete all the evaluation enabler codes, if required
- Upgrade or downgrade the base enabler, if required
- Apply the license key on the NetWorker server
- Product licenses
- Troubleshooting and Best Practices
Dell NetWorker 19.13 Licensing Guide
Conversion from served to unserved license
Go to the software licensing central to change the license type from served to unserved by performing a Rehost and then selecting the type as Unserved in the drop-down page of Step3: Enter Rehost details and select the type as Unserved.
You need the following details to complete this process:
- IP address and the hostname of the license server using which the served license was generated.
- IP address and the hostname of the NetWorker server for which the unserved license needs to be generated.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\