Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

e_d_tov

Configures the E_D_TOV FC timer value for every vfabric.

Syntax
e_d_tov timeout-val
Parameters
timeout-val—Valid values are from 1000 to 10000.
Defaults
2000 ms
Command Mode
Vfabric CONFIGURATION
Usage Information
  • The configurations are supported only in the multiswitch mode.
  • If you do not receive an expected response within the expected time, then consider the condition as an error condition. This timer is used for the error conditions during link initialization, and the principal switch election. Match this value with the other end during port initialization. This type of configuration is not permitted when vfabric is active.
  • If the configured E_D_TOV value is not same on both the sides of the port, then the port is isolated. Ensure to configure the same E_D_TOV value on both the sides.
  • You can change the E_D_TOV value only when vfabric is in inactive state. The vfabric is activated only by adding vlan and fcmap configuration under the vfabric configuration view. Ensure to configure E_D_TOV before configuring the vlan and fcmap in the vfabric configuration view.
  • The no version of this command resets to the default value.
Example 
OS10(conf-vfabric-<vfabric-id>)#e_d_tov 3000
Supported Releases
10.5.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\