Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

profile

Configures breakout interfaces on a Z9264F-ON switch.

Syntax
profile {restricted | unrestricted}
Parameters
  • restricted — Applies only to the odd-numbered port within the port group. The even-numbered port in the port group is disabled. Supported speeds are:
    • 100g-1x
    • 40g-1x
    • 25g-4x
    • 10g-4x
  • unrestricted — Applies to both the odd-numbered and even-numbered ports within the port group. Supported speeds are:
    • 100g-1x
    • 50g-2x
    • 40g-1x
Default
Unrestricted
Command mode
PORT-GROUP
Usage information
Enter the profile command to configure breakout interfaces. Use the port command to specify the speed. The Z9264F-ON switch has a total of 64 physical ports and can support a maximum of 128 logical ports. To view the ports that belong to a port group, use the show port-group command.
Example
OS10(config)# port-group 1/1/2
OS10(conf-pg-1/1/2)# profile restricted
Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\