Create a repository file (for example, dtk.repo)
for the required operating system in a writable location. The corresponding
RPMs for the operating system are located at /mnt/cdrom/RPMs/<OS>, where OS can be the supported Linux operating system.
For example, to deploy DTK RPMs on RHEL 6.x, you can
use the following content in dtk.repo file:
Use the following command to install DTK RPMs: yum
install -c dtk.repo -y <RPM>, where <RPM> can
be DTK binaries.
NOTE: For both
installations, the raidcfg and syscfg binaries and libraries
are installed at /opt/dell/toolkit/bin. The racadm binaries are installed at /opt/dell/srvadmin/bin and /opt/dell/srvadmin/sbin.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\