Q: Can I use the SYSCFG utility to configure
Point-to-Point Protocol (PPP) over the serial port to access my RAC?
A: No. The Baseboard Management Controller (BMC) firmware
does not support PPP configurations for the serial port.
Q: The SYSCFG utility --lancfgparams option has suboptions that configure the IP address, Gateway, and
Subnet Mask for the system BMC. There is also a MAC address. Are these
the same as the operating system network parameter of the managed
system?
A: No. The Baseboard Management Controller (BMC) has its
own IP address, Gateway, Subnet Mask, and MAC address values.
Q: What is the minimum configuration needed to support BMC
Platform Event Filtering?
A: You must enable LAN-channel access pefalerting and ensure that you set the BMC IP address and Gateway values for
alerting.
Q: I installed the factory defaults for the BMC of my system.
Then, I enabled BMC user ID 3. What is the username for this user
ID?
A: The default username for user IDs 3 to 10 is NULL.
Q: Can I use this NULL username to remotely
log in to a BMC of a system?
A: No. Remote login using a NULL username is not allowed. It is recommended that you always provide
a non-null, valid username for the user ID when you enable a BMC user
ID.
Q: Are duplicate usernames allowed in the BMC?
A: No. If you enter a username value that already exists,
the SYSCFG utility returns an error code of
89, which means This username is already in use. Enter a
unique username.
Q: In --solcfgparams, when I set the
Serial Over LAN (SOL) character send threshold using solcharsendthreshold to be 225, I get a Hardware subsystem error. Invalid data
field in request. What are the valid values?
A: The range of valid values for --solcfgparams and --solcharsendthreshold are from 1 to
220.
Q: How do I enable console redirection on a modular system?
A: Set the --serialcomm option value
to enableconred. For example, syscfg
-serialcomm=enableconred.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\