Add or edit device details for Power Manager monitored devices
Add device details for devices monitored through Power Manager for accurate rack management.
About this task
NOTE If you are logging in as a Device Manager, only the device groups and devices that are in your scope are available for viewing and management.
For example, if you are logging in as a Device Manager DM1 user, you can view and edit the device details that are part of groups that are in Device Manager DM1 user scope. However, as a Device Manager DM1 user, you cannot add any device to the group in your scope.
To add or edit the device details, perform the following steps:
Steps
Launch OpenManage Enterprise.
On the
Devices page, select a device by clicking anywhere on the row except on the
Name and
IP Address columns.
Scroll down to the end of the page to view the
Device Details for
Power Manager section on the bottom-right side of the page.
Click
Update Details.
The
Device Detailsfor
Power Manager page is displayed.
Provide the size of the device in the rack Unit and maximum power consumption of the device in Watts and click
Apply.
The power value is automatically converted to BTU and displayed.
The details for the device are updated.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\