Dell EMC OpenManage Essentials Version 2.5 User's Guide

Configuring SNMP Services on Windows

  1. Open a command run prompt and type services.msc to open the Services MMC.
  2. Right-click SNMP Service, and select Properties. If you cannot locate SNMP Service, you must install it using Add/Remove Windows Components.
  3. Click Security and ensure that Accept SNMP packets from any host is selected.
  4. Under Accepted Community Names, ensure that public (or a customized community string) is set. If not set by default, click Add, and type a community string in Community Name. Also select community rights as READ ONLY or READ WRITE.
  5. Click Traps and ensure that the community string field has a valid name.
  6. In Trap destination, click Add and enter the Open Manage Essential Console IP address.
  7. Start the service.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\