Dell EMC OpenManage Essentials Version 2.5 User's Guide

Editing a discovery range group

Description: The Set-ModifyDiscoveryRangeGroup command allows you to edit an existing discovery range group. You can change the protocols for the discovery range group by specifying a DiscoveryProfile.xml file which changes the current protocol settings for the specified group. For information about the DiscoveryProfile.xml file, see Creating a Discovery Profile Input File .

Command:
PS> Set-ModifyDiscoveryRangeGroup -GroupName <groupname> –Profile <DiscoveryProfile.xml> -AddRangeList <rangelist .xml or
                                    .csv file>
                                 
Example:
  • Change a discovery range group’s discovery profile and add new ranges to the discovery range group using an XML file:
    PS> Set-ModifyDiscoveryRangeGroup -GroupName WebServers-TX -Profile .\samples\snmp_only.xml -AddRangeList .\samples\new_ranges.xml
  • Change a discovery range group’s discovery profile and add new ranges to the discovery range group using a CSV file:
    PS> Set-ModifyDiscoveryRangeGroup -GroupName WebServers-TX -Profile .\samples\snmp_only.xml -AddRangeListCSV .\samples\new_ranges.csv
  • Add new ranges to a discovery range group using an XML file (retaining the previously discovered profile):
    PS> Set-ModifyDiscoveryRangeGroup -GroupName WebServers-TX -AddRangeList .\samples\new_ranges.xml
  • Add new ranges to a discovery range group using a CSV file (retaining the previously discovered profile):
    PS> Set-ModifyDiscoveryRangeGroup -GroupName WebServers-TX -AddRangeListCSV .\samples\new_ranges.csv

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\