The requirements for the managed systems are as follows:
Table 1. Supported firmware versions for Dell EMC PowerEdge ServersSupported firmware versions for Dell EMC PowerEdge Servers
Dell EMC PowerEdge Servers
Firmware Versions
iDRAC9 based PowerEdge servers
5.10.10.00 and later versions
12th and 13th Generations PowerEdge servers
2.63.60.61 and later versions
NOTE HCI, DSS devices also supports 13th generation and iDRAC9
Table 2. Supported firmware versions for PowerEdge ChassisSupported firmware versions for M1000e, MX7000, VRTX, FX2/FX2s
Dell EMC PowerEdge Chassis
CMC versions
PowerEdge M1000e Chassis
6.1 and later versions
PowerEdge MX7000 modular chassis
1.1 and later versions
PowerEdge VRTX chassis
3.2 and later versions
PowerEdge FX2/FX2s chassis
2.2 and later versions
Table 3. Supported firmware versions for StorageSupported firmware versions for Storage
Dell EMC Storage Arrays
Supported Firmware versions
Compellent SC-Series Storage Arrays
7.2.1 and later versions
EqualLogic PS-Series Storage Arrays
9.1.4 and later versions
PowerVault MD 34/38 Series Storage Arrays
08.25.11.60 and later versions
PowerVault ME4 Storage Arrays
GT275R005-04 and later versions
Table 4. Supported firmware versions for Network switchesSupported firmware versions for network switches
Dell EMC Operating System based Network switches
Supported firmware versions
Operating System 6
6.6.0.13 and later versions
Operating System 9
19.4.1.8 and later versions
Operating System 10
10.5.1.0 and later versions
NOTE iDRAC versions are not applicable for Storage and network switches.
If you are using SNMP protocol, ensure that SNMP is configured in the respective devices.
If you want to receive SNMP traps in the Nagios Core console, ensure that you configure the SNMP trap destination in the respective devices.
For more information, see
Appendix in the
Dell EMC OpenManage Plug-in Version 3.2.0 for Nagios Core Users Guide at
dell.com/support
If you are using WSMan protocol, it is recommended that you use a WSMan service account other than the default service account. For more information, see
Configuring User Accounts and Privileges in the respective device’s User’s Guide at
Dell.com/support
For the list of supported platforms, see
Support Matrix in the
Dell EMC OpenManage Plug-in Version 3.2.0 for Nagios Core User’ Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\