Dell OptiPlex 3020–Mini Tower Owner's Manual

Installing the I/O Panel

  1. Insert the I/O panel into the slot on the chassis front.
  2. Slide the I/O panel towards the right of the computer to secure to the chassis.
  3. Tighten the screw to secure the I/O panel to the chassis.
  4. Thread the I/O panel and USB data cable into the chassis clip.
  5. Connect the I/O panel and USB data cable to the system board.
  6. Install :
    1. front bezel
    2. cover
  7. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\