Dell OptiPlex 3020–Mini Tower Owner's Manual

Removing the Intrusion Switch

  1. Follow the procedures in Before Working Inside Your Computer .
  2. Remove the:
    1. cover
    2. heatsink assembly
  3. Perform the following steps as shown in the illustration:
    1. Press the intrusion-switch cable [1].
    2. Disconnect the intrusion-switch cable from the system board [2].
    3. Slide the intrusion switch toward the bottom of the chassis and remove it from the computer
      Figure displaying how to disconnect the intrusion cable from the system board and chassis.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\