Dell OptiPlex 3020M Owner's Manual

Installing the Dell OptiPlex Micro Console with DVD-RW

Recommended Screws:

	Screw Type	Used in
	ST4 x 13 mm, Wooden screw	Wooden table

1. Perform the following steps as shown in the illustration:
   1. Loosen the screws that secure the cover to the optical drive console [1].
   2. Slide and lift the cover upwards to remove it from the console [2].

   

2. Perform the following steps as shown in the illustration:
   1. Slide the computer into the slot [1].
   2. Tighten the screw to secure the computer to the optical drive console [2].

   

3. Perform the following steps as shown in the illustration:
   1. Cut the strap of the power adapter cable [1].
   2. Slide and insert the power adapter into the slot [2].
   3. Route the cable through the notch to secure it [3].

   

4. Perform the following steps as shown in the illustration:
   1. Open the cable management clip [1].
   2. Lift the antenna cable out [2].
   3. Connect the antenna cable to the antenna connector [3].

   

5. Route the USB cables through the cable management clip and connect them to the computer. Close the cable management clip.

   

6. Perform the following steps as shown in the illustration:
   1. Prepare the wooden table by installing screws for mounting the optical drive console.
   2. Align the slots on the optical drive console with the screws on the table and slide the optical drive console and lock it.
   3. Tighten the screws to secure the optical drive console to the wooden table.

   

7. Install the antenna to the optical drive console.

   

8. Perform the following steps as shown in the illustration:
   1. Slide and insert the cover to its position [1].
   2. Tighten the screws to secure the cover to the chassis [2].