Dell OptiPlex 3020M Owner's Manual

PDF

Installing the Dell OptiPlex Micro Dual VESA Mount

Recommended Screws:
Screw TypeUsed in
Figure displaying pan headscrew.
M4 x L10 mm, Pan head screwMonitor

Prerequisite: Install the power adapter.

  1. Align the dual VESA mount behind the monitor and tighten the screws to secure the dual VESA mount to the monitor.
    Figure displaying how to connect dual VESA mount behind the monitor.
  2. Perform the following steps as shown in the illustration:
    1. Slide the computer into the dual VESA mount. [1]
    2. Rotate the screw in clockwise direction to secure the computer to the dual VESA mount. [2]
    Figure displaying how to insert the system into the dual VESA mount.
  3. Slide the power adapter case through the grooves at the bottom of the dual dual VESA mount to lock it.
    Figure displaying how to attach the power adapter to the dual VESA mount.
  4. Connect all the cables and antenna to the computer.
    Figure displaying how to insert all the cables and antenna to the system.
  5. Tighten the screws to secure the arm stand to the dual VESA mount.
    Figure displaying how to connect the arm stand to the dual VESA mount.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\