Dell OptiPlex 3020M Owner's Manual

PDF

Installing the Dell OptiPlex Micro VESA Mount

Recommended Screws:
Screw TypeUsed in
Figure displaying pan head screw.
M4 x L10 mm, Pan head screwMonitor
Figure displaying wooden screw.
ST4 x L13 mm, Wooden screw Wooden table

Prerequisite: Install the power adapter.

  1. Perform the following steps as shown in the illustration:
    1. Tighten the screws to secure the VESA mount to the table.
    2. Slide the computer into the VESA mount [1].
    3. Tighten the screw to secure the computer to the VESA mount [2].
    Figure displaying how to insert the computer into the VESA mount.
  2. Perform the following steps as shown in the illustration:
    1. Slide the power adapter case through the grooves at the bottom of the VESA mount to lock it.
    2. Connect all the cables and install antenna to the computer.
    Figure displaying how to insert the adapter and cables to the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\