Dell OptiPlex 3020M Owner's Manual

PDF

Installing the PS2 and Serial Connector Board

  1. Place the PS2 and serial connector board into its slot.
  2. Tighten the screws that secure the PS2 and serial connector board to the base panel.
  3. Connect the cable to the PS2 and serial connector board.
  4. Install the cover.
  5. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\