Dell OptiPlex 3020M Owner's Manual

PDF

Installing the System Board

  1. Place the system board on the computer.
  2. Tighten the screws to secure the system board to the base panel.
  3. Place the hard drive holder on the system board.
  4. Tighten the screws that secure the hard-drive holder to the system board.
  5. Install:
    1. coin-cell battery
    2. WLAN card
    3. PS2 or serial connector board
    4. processor
    5. memory
    6. heatsink
    7. hard drive
    8. processor fan module
    9. cover
  6. Follow the procedures in After Working Inside Your Computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\