The dust filter for the Dell OptiPlex Micro helps protect the system from fine dust particles. After installation, the BIOS
can be enabled to generate a pre-boot reminder to clean or replace the dust filter based on the time interval set.
Follow these steps to install the dust filter:
Align the top edge of the dust filter (1) to the top edge of the system and press the lower edge of the dust filter to close
over the system (2).
Gently press as shown to ensure the filter fits snugly onto the system.
Re-start the system and press
F2 to enter the BIOS Setup menu.
In the BIOS Setup menu, navigate to
System Configuration >
Dust Filter Maintenance and select from any of the following intervals: 15, 30, 60, 90, 120, 150, or 180 days.
NOTE: Default setting: Disabled.
NOTE: Alerts are generated only during a system re-boot and not during normal OS operation.
To clean the dust filter, brush or gently vacuum and then wipe down the external surfaces with a moist cloth.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\