Dell OptiPlex 3060 Tower Service Manual

PDF

Installing intrusion switch

  1. Insert the intrusion switch into the slot on the system [1].
  2. Route the intrusion switch cable through the fan grommet [2].
  3. Connect the intrusion switch cable to the connector on the system board [3].
    Installing intrusion switch
  4. Close the front panel door.
  5. Install the:
    1. Front bezel
    2. Side cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\