Dell OptiPlex 3060 Tower Service Manual

PDF

Installing optional VGA module

  1. Insert the VGA module into its slot from the inside of your computer [1] and connect the VGA cable to the connector on the system board [2].
    Placing the VGA module into the slot
  2. Replace the two (M3X3) screws to secure the optional VGA module to the system.
    Installing the VGA module
  3. Install the system fan .
  4. Close the front panel door.
  5. Install the:
    1. Front bezel
    2. Side cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\