Dell OptiPlex 3060 Tower Service Manual

PDF

Installing PCIe expansion card

  1. To install the PCIe expansion card:
    1. NOTE To remove the PCIe brackets, push the bracket upwards from the inside of your computer to release it and then lift the bracket away from your computer.
      Insert a screwdriver in the hole of a PCIe bracket and push hard to release the bracket 4, and then lift the bracket out from your computer.
    2. Insert the PCIe expansion card to the connector on the system board [1].
    3. Secure the PCIe expansion card by pushing the card retention latch until it clicks into place [2].
      NOTE This step is applicable only for the connector with card retention latch, otherwise, skip this step.
      Installing PCIe card
    4. Pull the release latch forward to close [3].
    5. Repeat the steps to install any additional PCIe expansion card.
  2. Close the front panel door.
  3. Install the:
    1. Front bezel
    2. Side cover
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\