Dell OptiPlex 3060 Tower Service Manual

PDF

Removing optional VGA module

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. Side cover
    2. Front bezel
  3. Open the front panel door.
  4. Remove the system fan.
  5. To remove the optional VGA module:
    1. Remove the two (M3X3) screws that secure the optional VGA module to the system.
      Removing the screws
    2. Disconnect the VGA cable from the connector on the system board [1].
    3. Remove the VGA module from the system [2].
      Disconnecting the VGA module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\