OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the M.2 2280 PCIe solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.

Steps

  1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
  2. Insert the solid-state drive at a 45-degree angle into the system board.
  3. Replace the screw (M2X3) that secures the M.2 PCIe solid-state drive to the system board.

Next steps

  1. Install the 2.5 in. hard drive assembly.
  2. Install the front bezel.
  3. Install the side cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\