OptiPlex 5050 Tower Owner's Manual

PDF

Installing intrusion switch

Steps

  1. Insert the intrusion switch into the slot on the computer.
  2. Route the intrusion switch cable through the fan grommet.
  3. Connect the intrusion switch cable to the connector on the system board.
  4. Close the front panel door.
  5. Install the:
    1. bezel
    2. cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\