OptiPlex 5050 Tower Owner's Manual

PDF

Installing power switch

Steps

  1. Insert the power switch into the slot from the front of the computer and press it until it clicks into place.
  2. Route the power switch cable through the retention clip.
  3. Align the cable with the pins on the connector and connect the cable.
  4. Close the front panel door.
  5. Install the:
    1. bezel
    2. cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\