OptiPlex 5050 Tower Owner's Manual

PDF

Installing SD card reader

Steps

  1. Insert the SD card reader into the slot on the system board.
  2. Tighten the screw to secure the SD card reader to the front panel door.
  3. Connect the SD card reader cable to the connector on the system board.
  4. Close the front panel door.
  5. Install the:
    1. bezel
    2. cover
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\