OptiPlex 5050 Tower Owner's Manual

PDF

Installing VGA daughter board

Steps

  1. Align the VGA daughter board with the screw holder on the system board.
  2. Tighten the screw to secure the VGA daughter board to the system board.
  3. Insert the VGA connector into the slot at the back of the computer.
  4. Tighten the screws to secure the VGA connector to the computer.
  5. Close the front panel door.
  6. Install the:
    1. bezel
    2. cover
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\