OptiPlex 5050 Tower Owner's Manual

PDF

Removing intrusion switch

Steps

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
  3. Open the front panel door.
  4. To remove the intrusion switch:
    1. Disconnect the intrusion switch cable from the connector on the system board [1] [2].
    2. Unroute the intrusion switch cable from the fan grommet.
    3. Slide the intrusion switch and push it to remove from the computer [3].
    Figure displaying how to remove the intrusion switch from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\