OptiPlex 5050 Tower Owner's Manual

PDF

Removing power switch

Steps

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
  3. Open the front panel door.
  4. To release the power switch:
    1. Disconnect the power switch cable from the system board [1].
    2. Unroute the power switch cable through the retention clip [2].
    3. Press the release tabs using a plastic scribe and slide the power switch out from the front of the computer [2,3].
    4. Close the front panel door [4].
    Figure displaying how to release the power switch from the computer.
  5. Pull the power switch out from the computer.
    Figure displaying how to remove the power switch from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\