OptiPlex 5050 Tower Owner's Manual

PDF

Removing SD card reader

Steps

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
  3. Open the front panel door.
  4. To remove the SD card reader:
    1. Disconnect the SD card reader cable from the connector on the system board [1].
    2. Remove the screw that secures the SD card reader to the front panel door [2].
    3. Lift the SD card reader out of the computer [3].
    Figure displaying how to remove the SD card reader from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\