OptiPlex 5050 Tower Owner's Manual

PDF

Removing the 2.5–inch drive from the drive bracket

Steps

  1. Follow the procedure in Before Working Inside Your Computer.
  2. Remove the:
    1. cover
    2. bezel
    3. 2.5–inch drive assembly
  3. To remove the drive:
    1. Pull one side of the drive bracket to disengage the pins on the bracket from the slots on the drive [1].
    2. Lift the drive out of the drive bracket [2].
      Figure displaying how to disconnect the hard drive assembly cables from the connectors on the hard drive

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\