Dell OptiPlex 5270 All-in-One Setup and specifications guide
Power Management screen options
- Option
- Description
- AC Recovery
- Allows you to enable or disable the computer from
turning on automatically when an AC adapter is connected.
- Power Off (default)
- Power On
- Last Power State
- Enable Intel Speed Shift Technology
- This option is used to enable or disable the Intel speed shift technology support. The option is enabled by default.
- Auto On Time
- Allows you to set the time at which the computer must
turn on automatically. The options are:
- Disabled
- Every Day
- Weekdays
- Select Days
Default setting: Disabled
- Deep Sleep Control
- Allows you to aggressive the system is at conserving
power while Shut down (S5) or in Hybernate (S4) mode.
- Disabled (default)
- Enabled in S5 only
- Enabled in S4 and S5
- Fan Control Override
- Controls the speed of the system fan. This option
is disabled by default.NOTE: When enabled, the fan runs at full speed.
- USB Wake Support
- Allows you to enable USB devices to wake the system
from Standby.NOTE: This feature is only functional when the AC power adapter is connected. If the AC power adapter is removed during Standby, the system setup removes power from all the USB ports to conserve battery power.
- Enable USB Wake Support
Default setting: The option is enabled..
- Wake on LAN/WLAN
- Allows you to enable or disable the feature that powers
on the computer from the Off state when triggered by a LAN signal.
- Disabled: This option is enabled by default.
- LAN Only
- WLAN Only
- LAN or WLAN
- LAN with PXE Boot
- Block Sleep
- This option lets you block entering to sleep (S3 state)
in operating system environment.
Block Sleep (S3 state)
Default setting: This option is disabled
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\