OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Installing the heat sink assembly

  1. Place the heat sink assembly onto the processor.
  2. Tighten the captive screws to secure the heat sink assembly to the system board.
  3. Connect the heat sink assembly cable to the system board.
  4. Install the:
    1. optical drive
    2. 2.5–inch drive assembly
    3. bezel
    4. cover
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\