OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing intrusion switch

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
  3. To remove the intrusion switch:
    1. Disconnect the intrusion switch cable from the connector on the system board [1][2].
    2. Slide the intrusion switch and lift it away from the computer [3].
    Figure displaying intrusion switch removal.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\