OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing memory module

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
    3. 2.5–inch drive assembly
    4. optical drive
  3. To remove the memory module:
    1. Push the memory module retention tabs on both sides of the memory module.
    2. Lift the memory module from the memory module connector on the system board.
    Figure displaying how to remove the memory module from the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\