OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing power supply unit or PSU

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
    3. 2.5–inch drive assembly
    4. optical drive
  3. To release the PSU:
    1. Disconnect the power cable from the system board [1] [2].
    2. Unroute the power cables from the retention clips on the chassis [3] [4].
    Removing power supply unit or PSU
  4. To remove the PSU:
    1. Disconnect the power cable from the system board [1] [2].
    2. Lift the cables away from the computer [3].
    3. Remove the screws that secure the PSU to the computer [4].
    Removing power supply unit or PSU
  5. Press the blue release tab [1], slide the PSU and lift it away from the computer [2].
    Removing power supply unit or PSU

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\