OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing processor

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. 2.5–inch drive assembly
    3. Optical drive
    4. heat sink assembly
  3. To remove the processor:
    1. Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1].
    2. Lift the lever upward and lift the processor shield [2].
    3. Lift the processor out of the socket [3].
    Removing processor

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\