OptiPlex 7050 Small Form Factor Owner's Manual

PDF

Removing system board

NOTE:Depending on the configuration you order, you may see either of the heat sinks as shown in the image below.

Heat sink

  1. Follow the procedure in Before working inside your computer.
  2. Remove the:
    1. cover
    2. bezel
    3. 2.5–inch drive assembly
    4. optical drive
    5. heat sink
    6. processor
    7. expansion card
    8. memory module
    9. M.2 PCIe SSD
    10. SD card reader
  3. To remove the I/O panel:
    1. Remove the screw that secures the I/O panel [1].
    2. Slide and push toward the front from the computer [2].
    Removing system board
  4. Disconnect the following cables from the system board:
    1. speaker [1]
    2. 2.5–inch drive [2]
    3. optical drive [3]
    4. Data cable [4]
    Removing system board
  5. Disconnect the following cables and screw from the system board:
    1. PSU [1]
    2. hard drive and optical drive caddy stand off screw [2]
    3. PSU [3]
    4. power switch [4]
    5. intrusion switch [5]
    Removing system board
  6. To remove the system board:
    1. Remove the screws that secure the system board to the computer [1].
    2. Slide and lift the system board away from the computer [2].
    Removing system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\