OptiPlex 7090 Ultra Setup and specifications guide

Installing device on Wall Mount

1. Full Function
   1. Press the release button to open the cable cover.
      
   2. Align the screw holes on the wall mount in the wall and mark them against the wall using a pencil.
      
   3. Drill the screw marks on the wall and insert the three screw anchors into the screw holes in the wall.
      
   4. Align the screw holes on the wall mount with the screw holes on the wall and install the three screws to secure the wall mount in the wall.
      
   5. Align the screw holes on the device with the screw holes on the wall mount bracket.
   6. Install the four screws to secure the device to the wall mount bracket.
      
   7. Insert the hooks on the mounting bracket of the wall mount into the slots on the wall mount bracket module.
   8. Align and insert the hooks on the wall mount bracket module into the slots on the wall mount until it clicks into place
      
   9. Connect the power, network, keyboard, mouse, and display cables to the device and to the power outlet.
      
   10. To avoid any pinching or crimping of the cables while closing the stand cover, it is recommended that you route the cables as indicated in the image.
       NOTE All the cables and ports are used depending on the peripherals chosen and the configuration of the computer.
       
   11. Close the stand cover.
       
   12. Lock the device and the stand cover.
       
2. Simple Function
   1. Align the screw holes on the wall mount in the wall and mark them using a pencil.
      
   2. Drill the screw marks on the wall and insert the two screws into the screw holes in the wall.
      
   3. Align the screw holes on the device with the screw holes on the wall mount bracket.
   4. Install the four screws to secure the device to the wall mount bracket.
      
   5. Connect the power, network, keyboard, mouse, and display cables to the device and to the power outlet.
      
   6. Align the screws on the wall with the retention clips on the wall mount bracket module.
   7. Mount the wall mount bracket module in the screws on the wall.
      
   8. Press the power button to turn on the device.