Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell OptiPlex 9020M Owner's Manual

Installing the Dell OptiPlex Micro Console with DVD-RW

Recommended Screws :
 Screw TypeUsed in
Figure displaying wooden screw.
ST4 x 13 mm, Wooden screw Wooden table
  1. Perform the following steps as shown in the illustration:
    1. Loosen the screws that secure the cover to the optical drive console [1].
    2. Slide and lift the cover upwards to remove it from the console [2].
    Figure displaying how to remove the cover.
  2. Perform the following steps as shown in the illustration:
    1. Slide the computer into the slot [1].
    2. Tighten the screw to secure the computer to the optical drive console [2].
    Figure displaying how to insert the system into the optical drive console.
  3. Perform the following steps as shown in the illustration:
    1. Cut the strap of the power adapter cable [1].
    2. Slide and insert the power adapter into the slot [2].
    3. Route the cable through the notch to secure it [3].
    Figure displaying how to insert the power adapter.
  4. Perform the following steps as shown in the illustration:
    1. Open the cable management clip [1].
    2. Lift the antenna cable out [2].
    3. Connect the antenna cable to the antenna connector [3].
    Figure displaying how to connect the antenna cable.
  5. Route the USB cables through the cable management clip and connect them to the computer. Close the cable management clip.
    Figure displaying how to connect the cables to the system.
  6. Perform the following steps as shown in the illustration:
    1. Prepare the wooden table by installing screws for mounting the optical drive console.
    2. Align the slots on the optical drive console with the screws on the table and slide the optical drive console and lock it.
    3. Tighten the screws to secure the optical drive console to the wooden table.
    Figure displaying how to attach the system to the desk.
  7. Install the antenna to the optical drive console.
  8. Perform the following steps as shown in the illustration:
    1. Slide and insert the cover to its position [1].
    2. Tighten the screws to secure the cover to the chassis [2].
    Figure displaying how to install the cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\